This is a bent “Clamp Screw” from my 1940s Craftsman 113 table saw. It holds the saw in place at the desired degree of tilt. Any ideas on how to straighten the bent threaded section out? Is that possible? Or should I look for a replacement bolt?

The Rev. Dev. A pastor-turned-programmer who solves problems with an eye for detail and a heart for people. Trying to make more friends. Loves books, tools, DIY, writing instruments, stationery, coffee, and watching educational videos on YouTube.
This is a bent “Clamp Screw” from my 1940s Craftsman 113 table saw. It holds the saw in place at the desired degree of tilt. Any ideas on how to straighten the bent threaded section out? Is that possible? Or should I look for a replacement bolt?